Dismiss Notice
Welcome to
Pinewood Derby Online, a forum for questions and discussions about everyone's favorite gravity powered racers!
CLICK HERE to register as a member today for full access to the forum, it's fast, simple, and absolutely free!

DIY guide pin

Discussion in 'Wheels and Axles' started by philcav7, Sep 26, 2021.

  1. philcav7

    philcav7 Pack Champion

    Messages:
    24
    Likes Received:
    9
    Trophy Points:
    3
    Gender:
    Male
    Location:
    PA
    Is there any simple DIY guide pin methods?

    I was thinking of just cutting the head off an axle and bending it, but curious if there’s other solutions I’m not thinking off.
     
  2. Jupiter 2.9

    Jupiter 2.9 Workshop Leader Pro Racer

    Messages:
    195
    Likes Received:
    147
    Trophy Points:
    43
    Gender:
    Male
    Location:
    Jupiter Florida
    Paper clip
     
  3. philcav7

    philcav7 Pack Champion

    Messages:
    24
    Likes Received:
    9
    Trophy Points:
    3
    Gender:
    Male
    Location:
    PA
    that is such an obvious solution.
    I tend to over analyze things. I would have never thought of that.
     

Share This Page